処女の最初のセックス

	Which is better the M-50 and i-50 ,tool setters should be used to measure of φ6mm endmill?
	We recommend M-50.
	Although the cutting edge of the end mill has two blades, three blades, four blades, the cutting edges are not the same. Either one has been lengthened. If you use the M-50, it will detect the longer one by hitting it on the sensor plate, so no measurement error will occur. When i-50 is used, it is necessary to measure for each cutting edge. i-50 is recommended for measurement of small-diameter end mills with φ5 mm or less.
	φ5mm In the following small-diameter blade many small machining centers of measurement, we recommend i-50.
	Products that are relevant to this question is as follows. It will jump to the corresponding page by clicking. [Tool setter]

A professional manufacturer of three-dimensional measuring devices for the on-machine measurement and in-flight measurement