処女の最初のセックス

	I would like to measure the drill length of φ0.05 with a tool setter. Which is better, M-50 or i-50?
	In the measurement pressure, M-50 is 0.001N and i-50 is 0.2N, while M-50 is 1.5N. Please select i-50. For details, please see the page of tool setter. If it is overrun by Z axis feed, the endmill will break by M-50. The i-50 has a measurement pressure of 0.2N, but value does not change to 0.2N even if it overrun, it will not break even with the measurement of φ0.03mm endmill.
	i-50 is measuring pressure is 0.2N, but the value of even overkill reaction force does not change and 0.2N, does not break even in the measurement of cutlery φ0.03mm.
	Products that are relevant to this question is as follows. It will jump to the corresponding page by clicking. [Tool setter]

A professional manufacturer of three-dimensional measuring devices for the on-machine measurement and in-flight measurement