処女の最初のセックス

	The point finder exceeded the Z axis when measuring the plane.The stylus is slightly bent but it is not broken. LED does not light up. Can I sell the LED because I want to replace the LED?
	In the case of prod into the Z axis, there is a possibility that the electronic board at ehind is broken. Even if you get the LED, it can not be repaired. I will make a repair quote.
	Products that are relevant to this question is as follows. It will jump to the corresponding page by clicking. [Point Finder Series]　　[Tool Setter Series] [Centering Gauge Swing Type]

A professional manufacturer of three-dimensional measuring devices for the on-machine measurement and in-machine measurement