|
|
A professional manufacturer of three-dimensional measuring devices for the on-machine measurement and in-machine measurement |
 |
The lamp does not light, what is the cause? |
|---|---|
 |
Please confirm the following when it is before use. ① 【Common to all products】 Is the battery reversely inserted? Please confirm the direction of the battery once again. ②【Tool setter】 If the end mill is not conducting, it can not be measured with an external contact type measuring instrument. Please use i-50 【Point finder／Centering Gauge Swing Type】 Please use the internal contact type point finder WPi. When using the external contact method, please use the magunnet cable ,for the machining center with the spindle revolution number of 10,000 rpm or more. When the lamp stoped lighting after being used. ① There may be no remaining battery. Please try with a new battery once. ②【Point finder／Centering Gauge Swing Type】 If you use the machine for a long time, the spindle bearing wears and electric resistance is generated The LED may not emit light. Please use magnet cable. |
 |
Products that are relevant to this question is as follows. It will jump to the corresponding page by clicking. [Point Finder Series] [Tool Setter Series] [Centering Gauge Swing Type] |
Nissin Sangyo Co., Ltd. ―Measuring Instruments for The Machine Tools―Otsu 45-2, Kitamachi, Kanazawa, Ishikawa, Japan 920-0055 TEL：+81-76-223-1031 FAX：+81-76-223-1281
Copyright © 2007-2009 Nissin Sangyo Co., Ltd. All rights reserved.