処女の最初のセックス

	[Common] I lamp is not light, but either would be a failure?
	If you are using before, please check the following. ①[All products common] 　The batteries are not loaded in the wrong? Please check once again the 　orientation of the battery. ②[Tool setter] 　No electrical conductivity is end mill but if, it can not be 　measured by measuring instrument of external contact type. 　Please use the i-50. 　[Point finder / Centering Gauge Swing Type] 　Please use the internal contact type point finder WPi. 　Please use the magnet cable case of machining center spindle speed 　10000rpm or more. If the lamp is no longer emit light and from the beginning to use ①You may not have any remaining capacity of the battery. Try a new 　battery once. ②[Point finder / Centering Gauge Swing Type] 　There are cases where the main shaft bearing is worn when we have 　long-term use of mechanical, electrical resistance occurs, 　LED becomes difficult month. Please use the magnet cable. ...If the lamp does not light after trying the above, there is a possibility of failure. Because it will repair by checking the status, please contact your hardware store of purchase.
	Products that are relevant to this question is as follows. It will jump to the corresponding page by clicking. [Point Finder Series]　[Centering Gauge Swing Type] [Tool Setter Series]　[Centering gauge]